I am currently testing the jet45 avionics. Jet45 runs amazingly smooth on this configuration. regards Roel Hi Roel, you don’t need to edit the config file. with the software running, push “f” on your keyboard to show the window frame, then drag it to the monitor of your choice. Once there and positioned properly, type “f” again to go frameless, close the program, then reopen. It should appear in the location you placed it. There is a value in the ini file for x and y position. This value can be edited and is the pixel position according to your monitor setup. Once you perform the steps above, you should be able to open up the file and see the positions. Suggest you save off a copy of the file in case you need to restore the positions. Hey Jason. ahh...thats the trick! thanks i will try this Multiple avionics monitors on 1 pc
I have a pc equiped with a videocard where i can connect 5 monitors!
So far i use 4 monitors; 1 capt side 1 fo side, 1 standby gauges and 1 for the rmu’s
But how can i edit the ini files to start the correct software on a desired monitor?
i knew it had to be simple...
Forum Navigation
#1 · January 18, 2021, 8:35 am
#2 · January 18, 2021, 10:22 am
Jason Hite
FlightDeckSoft
#3 · January 18, 2021, 12:34 pm
2017-10-10